diff --git a/Bindings/clock/amlogic,meson8b-clkc.txt b/Bindings/clock/amlogic,meson8b-clkc.txt
new file mode 100644
index 0000000..cc51e47
--- /dev/null
+++ b/Bindings/clock/amlogic,meson8b-clkc.txt
@@ -0,0 +1,51 @@
+* Amlogic Meson8, Meson8b and Meson8m2 Clock and Reset Unit
+
+The Amlogic Meson8 / Meson8b / Meson8m2 clock controller generates and
+supplies clock to various controllers within the SoC.
+
+Required Properties:
+
+- compatible: must be one of:
+	- "amlogic,meson8-clkc" for Meson8 (S802) SoCs
+	- "amlogic,meson8b-clkc" for Meson8 (S805) SoCs
+	- "amlogic,meson8m2-clkc" for Meson8m2 (S812) SoCs
+- #clock-cells: should be 1.
+- #reset-cells: should be 1.
+- clocks: list of clock phandles, one for each entry in clock-names
+- clock-names: should contain the following:
+  * "xtal": the 24MHz system oscillator
+  * "ddr_pll": the DDR PLL clock
+  * "clk_32k": (if present) the 32kHz clock signal from GPIOAO_6 (CLK_32K_IN)
+
+Parent node should have the following properties :
+- compatible: "amlogic,meson-hhi-sysctrl", "simple-mfd", "syscon"
+- reg: base address and size of the HHI system control register space.
+
+Each clock is assigned an identifier and client nodes can use this identifier
+to specify the clock which they consume. All available clocks are defined as
+preprocessor macros in the dt-bindings/clock/meson8b-clkc.h header and can be
+used in device tree sources.
+
+Similarly a preprocessor macro for each reset line is defined in
+dt-bindings/reset/amlogic,meson8b-clkc-reset.h (which can be used from the
+device tree sources).
+
+
+Example: Clock controller node:
+
+	clkc: clock-controller {
+		compatible = "amlogic,meson8b-clkc";
+		#clock-cells = <1>;
+		#reset-cells = <1>;
+	};
+
+
+Example: UART controller node that consumes the clock generated by the clock
+  controller:
+
+	uart_AO: serial@c81004c0 {
+		compatible = "amlogic,meson-uart";
+		reg = <0xc81004c0 0x14>;
+		interrupts = <0 90 1>;
+		clocks = <&clkc CLKID_CLK81>;
+	};